Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 1998 >> Protege ES, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Self-Diagnostic System >> Operation Mode >> Using Cruise Indicator Light

Using Cruise Indicator Light

  1. Turn ignition switch to RUN position. Ensure cruise control main switch is off. Turn (press on Protege) and hold RESUME/ACCEL switch then press cruise control main switch to activate system inspection. Cruise indicator light should illuminate.
  2. Turn (press on Protege) SET/COAST switch. If output pattern 21 is retrieved, go to next step. If output pattern 21 is not retrieved, check cruise control switch circuit. See CRUISE CONTROL SWITCH CIRCUIT  under DIAGNOSTIC TESTS.
  3. Turn (press on Protege) RESUME/ACCEL switch. If output pattern 22 is retrieved, go to next step. If output pattern 22 is not retrieved, check cruise control switch circuit. See CRUISE CONTROL SWITCH CIRCUIT  under DIAGNOSTIC TESTS.
  4. Depress brake pedal. If output pattern 31 is retrieved, go to next step (A/T models) or step 6) (M/T models). If output pattern 31 is not retrieved, check brake switch circuit. See BRAKE SWITCH CIRCUIT  under DIAGNOSTIC TESTS.
  5. Place gear selector in Park or Neutral. If output pattern 35 is retrieved, go to step 7). If output pattern 35 is not retrieved, check transmission range switch circuit. See TRANSMISSION RANGE (TR) SWITCH CIRCUIT  under DIAGNOSTIC TESTS.
  6. Depress clutch pedal. If output pattern 35 is retrieved, go to next step. If output pattern 35 is not retrieved, check clutch switch circuit. See CLUTCH SWITCH CIRCUIT  under DIAGNOSTIC TESTS.
  7. Drive vehicle at a speed greater than 25 MPH. If output pattern 37 is retrieved, operation mode has passed. Perform condition detection mode. See CONDITION DETECTION MODE. If output pattern 37 is not retrieved, check vehicle speed sensor circuit. See VEHICLE SPEED SENSOR CIRCUIT  under DIAGNOSTIC TESTS.
scientia non olet · About Mike's Workshop Manuals