Removal & Installation
- Disconnect negative battery cable. ABS control module is mounted on hydraulic unit. See Fig 1
. Disconnect brakelines from hydraulic unit. Disconnect ABS control module electrical connector. Remove hydraulic unit mounting nuts. Remove ABS control module and hydraulic unit as an assembly.
- Remove ABS control module mounting bolt and screws. Separate ABS control module from hydraulic unit. See Fig 1
. To install, reverse removal procedure. Tighten ABS control module mounting screws to specification in a crisscross sequence. Tighten bolts and nuts to specification. See TORQUE SPECIFICATIONS
. Add fluid and bleed air from system. See BLEEDING BRAKE SYSTEM
.
Courtesy of MAZDA MOTORS CORP.