Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 1996 >> MPV DX >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heater System >> Testing >> Push-Button Control Panel >> Panel Illumination Light

Panel Illumination Light

  1. Remove heater control panel. See HEATER CONTROL PANEL under REMOVAL & INSTALLATION. Connect positive battery cable to terminal "h" of connector on back of control panel, and ground terminal "g". See Figure .
  2. Connect jumper wire between terminals "h" and "s". Connect a second jumper wire between terminals "g" and "t". Control panel illumination light should come on. If light does not come on, replace bulb.
scientia non olet · About Mike's Workshop Manuals