Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 1995 >> MX-3 Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Emission Systems & Sub-Systems >> Fuel Evaporation >> Check & Cut Valve

Check & Cut Valve

  1. Remove check and cut valve. Connect pressure gauge with "T" fitting to check and cut valve nipple leading to fuel tank. Cap opposite nipple. See Fig 1 .
  2. Blow air through port "A". Valve should open when pressure gauge indicates 0.92-1.20 psi (.065-.085 kg/cm2 ).
Fig 1: Testing Check & Cut Valve
G95C32534Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals