Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 1994 >> MPV LX >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Controls - Tests W/Codes) >> Self-Diagnostic System >> Retrieving Codes >> Accessing Trouble Codes

Accessing Trouble Codes

WARNING: This page is about a different car, the 1994 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using jumper wire, connect self-diagnostic connector terminals TEN and GND. See Fig 1 . Connector is located at back of left front wheelwell.
  2. With ignition on and engine stopped, observe malfunction indicator light (CHECK ENGINE). Note trouble codes. Check TROUBLE CODE IDENTIFICATION chart for possible cause. If light remains on continuously, MIL circuit is grounded or ECU is defective. If no codes are found, go to PIN VOLTAGE CHARTS article in the ENGINE PERFORMANCE section.
Fig 1: Locating Self-Diagnostic Connector
G91E16760Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals