Pinpoint Test P : The FCDIM (Front Control/Display Interface Module) Does Not Respond To The Diagnostic Scan Tool

WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

P1 CHECK THE FCDIM (FRONT CONTROL/DISPLAY INTERFACE MODULE) VOLTAGE SUPPLY CIRCUIT FOR AN OPEN

Ignition OFF.

Disconnect: FCDIM C2123.

Ignition ON.

Measure:

Positive Lead	Measurement / Action	Negative Lead
Refer to C2123-1	Courtesy of FORD MOTOR COMPANY	Ground

Is the voltage greater than 11 volts?

Yes

GO to P2

No	VERIFY the BCM fuse 32 (10A) is OK. If OK, REPAIR the circuit. If not OK, REFER to OEM Electrical Wiring Diagram Introduction to identify the possible causes of the circuit short.

P2 CHECK THE FCDIM (FRONT CONTROL/DISPLAY INTERFACE MODULE) GROUND CIRCUIT FOR AN OPEN

Ignition OFF.

Measure:

Positive Lead	Measurement / Action	Negative Lead
Refer to C2123-9	Courtesy of FORD MOTOR COMPANY	Ground

Is the resistance less than 3 ohms?

Yes

GO to P3

No	REPAIR the circuit.

P3 CHECK THE HS-CAN3 (HIGH-SPEED CONTROLLER AREA NETWORK 3) CIRCUITS BETWEEN THE FCDIM (FRONT CONTROL/DISPLAY INTERFACE MODULE) AND THE GWM (GATEWAY MODULE A) FOR AN OPEN

Disconnect: GWM C2431

Measure:

Positive Lead	Measurement / Action	Negative Lead
Refer to C2123-4	Courtesy of FORD MOTOR COMPANY	Refer to C2431-16
Refer to C2123-5	Courtesy of FORD MOTOR COMPANY	Refer to C2431-15

Are the resistances less than 3 ohms?

Yes

GO to P4

No	REPAIR the circuit in question.

P4 CHECK FOR CORRECT FCDIM (FRONT CONTROL/DISPLAY INTERFACE MODULE) OPERATION

Ignition OFF.

Disconnect and inspect the FCDIM connector and related in-line connectors.

Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins
- pushed-out pins - install new pins as necessary

Reconnect the FCDIM connector and related in-line connectors. Make sure they seat and latch correctly.

Operate the system and determine if the concern is still present.

Is the concern still present?

Yes	CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new FCDIM. REFER to: Front Control/Display Interface Module (FCDIM) .

No	The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.