Windshield Washer Fluid Level sensor: Removal
WARNING: This page is about a different car, the 2020 Lincoln Aviator. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation details.
- Siphon the windshield washer fluid out.
- Open the windshield washer fluid reservoir cap.
- Siphon the windshield washer fluid.
Use the General Equipment: Fluid Suction Gunx
Use the General Equipment: Fluid Suction GunUse the General Equipment: Fluid Container
- Remove the RH fender splash shield. Refer to: Fender Splash Shield .
- Disconnect the windshield washer fluid level sensor electrical connector.
-
NOTE: Be prepared to collect escaping fluid.
Remove the windshield washer fluid level sensor.
Use the General Equipment: Fluid Container