Pinpoint Test Ad : The Side Obstacle Detection Control Module LH (Sod-L) Does Not Respond To The Diagnostic Scan Tool: Notes
WARNING: This page is about a different variant/trim than selected.
Refer to MODULE COMMUNICATIONS NETWORK for schematic and connector information.
Normal Operation and Fault Conditions
The SODL communicates on the MS-CAN. Diagnostic messages are sent/received between the DLC and the diagnostic scan tool through the HS-CAN2 circuits at the DLC, and are translated through the GWM to the MS-CAN.
Possible Sources
- Fuse
- Wiring, terminals and connector
- SODL
Visual Inspection and Diagnostic Pre-checks
Verify BJB fuse 23 (15A) is OK.