Pinpoint Test AE : The Side Obstacle Detection Control Module LH (Sod-L) Does Not Respond To The Diagnostic Scan Tool: Notes
WARNING: This page is about a different variant/trim than selected.
Refer to Module Communications Network for schematic and connector information.
Refer to Vehicle Emergency Messaging System for schematic and connector information.
Normal Operation and Fault Conditions
The SODL communicates on the MS-CAN. Diagnostic messages are sent/received between the DLC and the diagnostic scan tool through the HS-CAN2 circuits at the DLC, and are translated through the GWM to the MS-CAN.
Possible Sources
- Fuse
- Wiring, terminals and connector
- SODL
Visual Inspection and Diagnostic Pre-checks
Verify BJB fuse 23 (15A) is OK.