Removal And Installation

NOTE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.

NOTE: Electronic modules are sensitive to electrical charges. The Anti-lock Brake System (ABS) module can be damaged if exposed to these charges.

NOTE: This step is only necessary if a new ABS module or a new Hydraulic Control Unit (HCU) is being installed.

Connect the scan tool and upload the module configuration information from the ABS module. For additional information, refer to Module Configuration .
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting .
Remove the battery tray. For additional information, refer to Battery, Mounting and Cables .
Disconnect the ABS electrical connector.
NOTE: Brake tubes must be installed in their original locations and orientations.

Loosen the brake tube-to-HCU fittings and position the brake tubes aside.
- To install, tighten to 23 Nm (17 lb-ft).
Loosen the 2 bracket-to-HCU nuts and remove the HCU.
- To install, tighten to 8 Nm (71 lb-in).
To install, reverse the removal procedure.
- If a new ABS module or HCU was installed, connect the scan tool and download the module configuration information from the scan tool. For additional information, refer to Module Configuration .
- Bleed the brake system. For additional information, refer to Brake System General Information .