Cruise-Control Module (C-CM): Removal

Cruise-Control Module (C-CM) or bracket 

• 1.
  
  With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting .

• 2.
  
  If a new C-CM is being installed, connect the scan tool and upload the module configuration information from the original C-CM. For additional information on configuration, refer to PMI in Module Configuration .

• 3.
  
  Remove the front bumper cover. For additional information, refer to Bumpers .

• 4.
  
  Gently pry the C-CM away from the retaining studs.
  • Disconnect the electrical connector.

• 5.
  
  Inspect the C-CM grommets for any damage and install new grommets as necessary.

Bracket 

• 6.
  
  Remove the 4 bolts and the C-CM bracket assembly.