Programming the Auto-Unlock Feature Using the Instrument Cluster (IC) Message Center

NOTE: The auto-unlock feature can be activated or deactivated independently of the autolock feature.

NOTE: The auto-unlock feature of the SJB can also be configured ON or OFF with the scan tool. For additional information on module configuration, refer to Module Configuration .

1.

Turn the ignition key from the OFF to the ON position.

2.

Press the SETUP button on the message center switch until AUTOUNLOCK ?ON> OFF is displayed.

3.

Press the RESET button to select ON or OFF. If auto-unlock is enabled, the message center will have brackets around the ?ON> display. If auto-unlock is disabled, the message center will have brackets around the ?OFF> display.