Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lincoln >> 2015 >> MKS Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Warning Systems >> Side And Rear Vision System >> Diagnosis And Testing >> Blind Spot Monitoring >> Pinpoint Tests >> Pinpoint Test E : The Sod-R Does Not Respond To The Scan Tool Or Cannot Be Configured >> Pinpoint Test E : The Sod-R Does Not Respond To The Scan Tool Or Cannot Be Configured

Pinpoint Test E : The Sod-R Does Not Respond To The Scan Tool Or Cannot Be Configured

NOTE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.
NOTE: Failure to disconnect the battery when instructed will result in false resistance readings. Refer to Battery, Mounting and Cables .

  1. E1 VERIFY THE SOD-R PASS THE NETWORK TEST

    • Enter the following diagnostic mode on the scan tool: Network Test.
    • Using a scan tool, perform the network test.

    Does the SOD-R pass the network test? 

    Yes  The system is operating correctly at this time. The concern may have been caused by high network traffic or an intermittent problem.
    No  GO to  E2.

  2. E2 CHECK THE SOD-R ADDRESS GROUND CIRCUIT FOR AN OPEN

    • Disconnect: Negative Battery Cable.
    • Disconnect: SOD-R C4370 .
    • Measure the resistance  between:
      Positive Lead Negative Lead
      Pin Circuit Pin Circuit
      C4370-6 GD313 (BK/GN) - Ground
    1. GFD89698Courtesy of FORD MOTOR COMPANY

    Is the resistance less than 3 ohms? 

    Yes  CONFIGURE the SOD-R. REFER to Module Configuration .
    No  REPAIR the circuit.
scientia non olet · About Mike's Workshop Manuals