Removal and Installation
-
NOTE: Module configuration is required when a new ACM is being installed.
Upload the ACM configuration information to the scan tool. For additional information, refer to PROGRAMMABLE MODULE INSTALLATION (PMI) .
- Remove the Front Controls Interface Module (FCIM). Refer to FRONT CONTROLS INTERFACE MODULE (FCIM) .
- Remove the 4 screws and slide the ACM
out.
- Disconnect the electrical connectors and the antenna cable connectors.
- To install, reverse the removal procedure.
- Download the configuration information to the ACM . For additional information, refer to PROGRAMMABLE MODULE INSTALLATION (PMI) .