Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lincoln >> 2013 >> MKT Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Information System And Entertainment System - 8 Inch Touchscreen) >> Description And Operation >> Information and Entertainment System >> System Operation >> Module Network Input Messages - APIM

Module Network Input Messages - APIM

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
Broadcast Message Originating Module Message Purpose
ACM radio functions ACM Used to display the ACM radio functions such as seek, tune and AM/FM stations on the FDIM.
Airbag status RCM Used to monitor airbag deployment status for 911 Assist™.
Audio source ACM Used to display the selected audio source on the FDIM.
CD load/eject ACM Used to display the loaded or ejected CD status on the FDIM.
Date and time IPC Used to display the current date and time on the FDIM.
Door ajar status BCM Used to determine the door ajar status for the accessory delay feature.
FCIM button press FCIM Used to indicate when a button is pressed on the FCIM so the audio system can make the desired setting change.
Front seat belt latched status RCM Used to mute speaker output so the Belt-Minder® tone can be more easily heard. This message only applies to vehicles with a MyKey® enabled and in use. The audio system is muted until the safety belt(s) are buckled.
Ignition key type BCM Used to determine if a MyKey® is enabled and in use.
Ignition status BCM Used to indicate the ignition state (OFF, ACCESSORY, RUN, and START) required for APIM operating modes and fault reporting.
Illumination dimming level BCM Used to control the backlight intensity of the FDIM based on the dimmer switch input.
Language selection IPC Used to display information on the FDIM in the selected language.
Navigation rolling wheel count ABS module Used to provide more accurate vehicle position tracking when the GPS signal is temporarily unavailable.
Seat belt buckle status RCM Used to mute speaker output so the Belt-Minder® tone can be more easily heard. This message only applies to vehicles with a MyKey® enabled and in use. The audio system is muted until the safety belt(s) are buckled.
Steering wheel switch media SCCM Used to set the audio system listening mode (AM/FM, CD, etc.) from the steering wheel switch.
Steering wheel switch seek left SCCM Used to access the next strong station to the left, to restart an audio track, to access the previous satellite radio station preset (if equipped), or the previous audio track from the steering wheel switch.
Steering wheel swtich seek right SCCM Used to access the next strong station to the right, to access the next satellite radio station preset (if equipped), or to access the next audio track from the steering wheel switch.
Steering wheel switch voice SCCM Used to access or exit the voice command feature from the steering wheel switch.
Steering wheel switch volume down SCCM Used to decrease the audio system volume from the steering wheel switch.
Steering wheel switch volume up SCCM Used to increase the audio system volume from the steering wheel switch.