Pinpoint Test D : The Occupant Classification System Module (OCSM) Does Not Respond To The Scan Tool

WARNING: This page is about a different car, the 2015 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Failure to disconnect the battery when instructed will result in false resistance readings.

D1 CHECK THE OCCUPANT CLASSIFICATION SYSTEM MODULE (OCSM) VOLTAGE SUPPLY CIRCUIT FOR AN OPEN

Ignition OFF.

Wait one minute.

Disconnect: OCSM C3159

Ignition ON.

Measure:

Positive Lead	Measurement / Action	Negative Lead
C3159-1	Courtesy of FORD MOTOR COMPANY	Ground

Is the voltage greater than 11 volts?

Yes

GO to D2

No	VERIFY the BCM fuse 86 (10A) is OK. If OK, REPAIR the circuit. If not OK, REFER to the OEM WIRING DIAGRAMS (ELECTRIC) article to identify the possible causes of the circuit short.

D2 CHECK THE OCCUPANT CLASSIFICATION SYSTEM MODULE (OCSM) GROUND CIRCUIT FOR AN OPEN

Ignition OFF.

Measure:

Positive Lead	Measurement / Action	Negative Lead
C3159-4	Courtesy of FORD MOTOR COMPANY	Ground

Is the resistance less than 3 ohms?

Yes

GO to D3

No	REPAIR the circuit.

D3 CHECK THE HIGH SPEED CONTROLLER AREA NETWORK (HS-CAN) CIRCUITS BETWEEN THE OCCUPANT CLASSIFICATION SYSTEM MODULE (OCSM) AND THE DATA LINK CONNECTOR (DLC) FOR AN OPEN

Measure:

Positive Lead	Measurement / Action	Negative Lead
C3159-2	Courtesy of FORD MOTOR COMPANY	C251-9
C3159-3	Courtesy of FORD MOTOR COMPANY	C251-12

Are the resistances less than 3 ohms?

Yes

GO to D4

No	REPAIR the circuit in question.

D4 CHECK FOR CORRECT OCCUPANT CLASSIFICATION SYSTEM MODULE (OCSM) OPERATION

Ignition OFF.

Disconnect and inspect the OCSM connector and related in-line connectors.

Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins
- pushed-out pins - install new pins as necessary

Reconnect the OCSM connector and related in-line connectors. Make sure they seat and latch correctly.

Operate the system and determine if the concern is still present.

Is the concern still present?

Yes	CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new OCSM. REFER to: Occupant Classification System (OCS) Sensor .

No	The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.