Diagnostic Aids

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

DTC U3000:41, the PSCM removes steering assist and enters into a manual mode. The module sends a message to the instrument panel cluster (IPC) to display POWER STEERING ASSIST FAULT in the message center.
DTC U3000:46, initially the PSCM uses a default steering assist and may set DTC U2100:00. If DTC U3000:46 returns on the next ignition cycle, the PSCM removes steering assist, enters into a manual mode and sends a message to the instrument panel cluster (IPC) to display POWER STEERING ASSIST FAULT in the message center.
DTC U3000:49, the PSCM removes steering assist and enters a manual mode. The module sends a message to the instrument panel cluster (IPC) to display POWER STEERING ASSIST FAULT in the message center.
For DTC U3000:96, the instrument panel cluster (IPC) displays SERVICE POWER STEERING NOW in the message center when this DTC is set. DTC U3000:96 cannot be cleared using the scan tool, to clear this DTC follow the pinpoint test instructions.

Failure	Action
41	GO to PINPOINT TEST B
46	GO to PINPOINT TEST B
49	GO to PINPOINT TEST B
96	GO to PINPOINT TEST C