C-CM Bracket: Installation

Bracket 

1. Install the 3 bolts and the C-CM bracket. Tighten the fasteners in the sequence shown in illustration.
   • Tighten the bolts to 8 Nm (71 lb-in).
     Fig 1: Identifying Cruise-Control Module Bracket Mounting Bolts Tightening Sequence

     Courtesy of FORD MOTOR CO.

     C-CM or bracket 

     NOTE: The vertical and horizontal alignment procedures need to be carried out to align the sensor.
2. NOTE: If one plastic grommet breaks while the C-CM is being installed, a new grommet should be installed.

   Firmly apply pressure to the C-CM so that it seats completely in the grommets.

3. Once the C-CM is installed, pull the C-CM to confirm that all 3 ball studs are fully seated in the grommets.
4. Connect the C-CM connector.
5. Do not install the front bumper cover until the alignment procedures are carried out.
   • Vertically and horizontally align the C-CM. For additional information, refer to CRUISE CONTROL MODULE (C-CM) (WITH SENSOR) ADJUSTMENT .