Pinpoint Tests - OSC Equipped Vehicle: Notes

	Fluke 77-IV Digital Multimeter FLU77-4 or equivalent
	Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool

Anytime an electrical connector or solenoid body is disconnected, inspect the connector for pin condition, corrosion and contamination. Also inspect the connector seal for damage. Clean, repair or install a new connector as required.

Prior to carrying out the pinpoint tests, check the following:

• Transmission fluid level
• Transmission fluid condition (burned, metal particles or discolored)
• Engine cooling system
• Other non-related transmission DTCs