Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lincoln >> 2012 >> MKS Base, AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System And Stability Control >> Removal And Installation >> Wheel Speed Sensor - Rear >> Removal and Installation

Removal and Installation

    NOTE: Make sure to correctly route and secure the wheel speed sensor harness in the rear subframe assembly or damage to the harness may occur.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the wheel speed sensor electrical connector.
  3. Detach the 2 wheel speed sensor pin-type retainers.
  4. Detach the 2 wheel speed sensor harness retainers.
  5. Remove the wheel speed sensor bolt.
    • To install, tighten to 15 Nm (133 lb-in).
  6. Remove the wheel speed sensor.
  7. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals