Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lincoln >> 2011 >> MKS Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1883 (Anti-Lock Brake System - Vehicle Dynamic Systems) >> Removal And Installation >> Anti-Lock Brake System (ABS) Module >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Electronic modules are sensitive to electrical charges. The Anti-lock Brake System (ABS) module can be damaged if exposed to these charges.
  1. Remove the Hydraulic Control Unit (HCU). For additional information, refer to HYDRAULIC CONTROL UNIT (HCU)  in this service information.
  2. Remove and discard the 4 screws.
    • To install, tighten the new screws to 3 Nm (27 lb-in).
  3. Remove the ABS module.
  4. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals