Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lincoln >> 2010 >> MKT Base, AWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Electronic Engine Controls >> Removal And Installation >> Intake Air Temperature (IAT) Sensor >> Removal and Installation

Removal and Installation

  1. Disconnect the Intake Air Temperature (IAT) sensor electrical connector.
  2. Remove the IAT  sensor.
    • Lift the tab and turn the IAT  sensor counterclockwise to remove.
    Fig 1: Locating Intake Air Temperature Sensor Electrical Connector
    G06253949Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
    • Make sure the IAT  sensor tab is fully seated during installation.
scientia non olet · About Mike's Workshop Manuals