Selector Lever: Installation
WARNING: This page is about a different car, the 2008 Mercury Milan, 2008 Lincoln MKZ, and 2008 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Install the selector lever and the 4 nuts.
- Tighten to 12 Nm (106 lb-in).
- Connect the electrical connector.
- Install the selector lever cable in the selector lever housing.
- Connect the selector lever cable end to the selector lever.
- Install the center console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
- Adjust the selector lever cable, refer to Selector Lever Cable Adjustment .
NOTE:
When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the selector lever cable end is snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the selector lever cable to click in place. Pull back on the selector lever cable to make sure that it is locked into the selector lever cable bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull back on the selector lever cable end to make sure that the selector lever cable end is correctly installed.