Removal And Installation
WARNING: This page is about a different car, the 2008 Mercury Milan, 2008 Lincoln MKZ, and 2008 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
NOTE:
Prior to the removal of the module, it is necessary to upload the module configuration information to the appropriate scan tool. This information needs to be downloaded into the new module once installed. For additional information, refer to MODULE CONFIGURATION
article.
- Upload the module configuration information from the driver seat module (DSM) into the scan tool. For additional information, refer to MODULE CONFIGURATION article.
- Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
- Remove the driver seat. For additional information, refer to SEATING article.
- Drill out the 2 rivets.
- Disconnect the 4 electrical connectors and remove the DSM.
- To install, reverse the removal procedure.
- Download the DSM configuration from the scan tool into the new DSM. For additional information, refer to MODULE CONFIGURATION article.