Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lincoln >> 2008 >> Navigator L 4WD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Control System >> Removal And Installation >> Charge Motion Control Valve (CMCV) >> Removal And Installation

Removal And Installation

  1. Remove the intake manifold. For additional information, refer to ENGINE - 5.4L (3V) article.
  2. Disconnect the charge motion control valve (CMCV) RH and LH rods from the intake manifold.
  3. Remove the stud bolt, the 2 bolts and the CMCV.
    • To install, tighten to 10 Nm (89 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals