Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lincoln >> 2008 >> MKX AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Information System And Entertainment Systems >> Removal And Installation >> Accessory Protocol Interface Module (APIM) >> Removal And Installation

Removal And Installation

NOTE: Accessory protocol interface module (APIM) reprogramming is only necessary if a new module is being installed.
  1. Verify the current APIM software and hardware level. For additional information, refer to Accessory Protocol Interface Module (APIM) Reprogramming in MODULE CONFIGURATION article.
  2. Remove the floor console rear trim panel by pulling straight back to disengage the clips.
  3. Disconnect the universal serial bus (USB) cable and the electrical connector.
  4. Remove the 4 screws and the APIM.
  5. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals