Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lincoln >> 2007 >> MKX AWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Control System >> Removal And Installation >> Knock Sensor (KS) >> Removal And Installation

Removal And Installation

  1. Remove the thermostat housing. For additional information, refer to ENGINE COOLING .
  2. Remove the lower intake manifold. For additional information, refer to ENGINE - 3.5L .
  3. Remove the coolant tube.
    • Discard the O-ring.
  4. Disconnect the knock sensor (KS) electrical connector.
  5. Remove the 2 bolts and the KS.
    • To install, tighten to 20 Nm (15 lb-ft).
  6. To install, reverse the removal procedure.
    • Lubricate the new O-ring with clean engine coolant.
scientia non olet · About Mike's Workshop Manuals