Digital Transmission Range (TR) Sensor: Installation

Install the digital TR sensor and loosely install the bolts.

Fig 1: Locating Digital TR Sensor Bolts
Courtesy of FORD MOTOR CO.

NOTE: Manual shift lever shaft must be in the NEUTRAL position.
Using the special tool, align the digital TR sensor slots. The tool is designed to fit snugly.

Fig 2: Aligning Digital TR Sensor Slots Using Special Tool (307-351)
Courtesy of FORD MOTOR CO.

CAUTION: Tightening one screw before tightening the other may cause the sensor to bind or become damaged.
Tighten the screws in an alternating sequence.
- Tighten to 9 Nm (80 lb-in).
  
  Fig 3: Aligning Digital TR Sensor Slots With Special Tool
  Courtesy of FORD MOTOR CO.
With the manual lever in overdrive, connect the shift lever control cable.
- Tighten to 30 Nm (22 lb-ft).
  
  Fig 4: Locating Transmission Shift Linkage Bolt
  Courtesy of FORD MOTOR CO.
Connect the digital TR sensor electrical connector.

Fig 5: Locating Digital TR Sensor Electrical Connector
Courtesy of FORD MOTOR CO.