Pinpoint Test F: No Communication With The Anti-Lock Brake System (Abs) Module

CAUTION: The Flex Probe Kit must be used for all test connections. Use of standard multimeter probes may damage wiring terminals.

F1 CHECK THE ANTI-LOCK BRAKE SYSTEM (ABS) MODULE POWER
- Key in OFF position.
- Disconnect: ABS Module C135.
- Key in ON position.
- Measure the voltage between ground and:
  - ABS module C135-8, circuit 88 (BK/WH), harness side.
  - ABS module C135-13, circuit 601 (LB/PK), harness side.
  - ABS module C135-14, circuit 483 (RD), harness side.
- Are the voltages greater than 10 volts?
Yes : GO to F2.

No : VERIFY BJB fuse 109 (20A) is OK. If OK, REPAIR circuit 483 (RD) for an open. TEST the system for normal operation.

VERIFY BJB fuse 106 (40A) is OK. If OK, REPAIR circuit 601 (LB/PK) for an open. TEST the system for normal operation.

VERIFY CJB fuse 17 (10A) is OK. If OK, REPAIR circuit 88 (BK/WH) for an open. TEST the system for normal operation.
F2 CHECK THE ABS MODULE GROUNDS
- Measure the resistance between ground and:
  - ABS module C135-15, circuit 57 (BK), harness side.
  - ABS module C135-12, circuit 57 (BK), harness side.
    
    Fig 1: Checking ABS Module Grounds
- Are the resistances less than 5 ohms?
Yes : REFER to MODULE COMMUNICATIONS NETWORK .

No : REPAIR circuit 57 (BK) for an open. CLEAR the DTCs. TEST the system for normal operation.