Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lincoln >> 2006 >> LS >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Safety Belt System >> Removal And Installation >> Child Safety Seat Tether Anchor >> Removal and Installation

Removal and Installation

WARNING: All safety belt assemblies including retractors, buckles, front seat belt buckle support assemblies (slide bar), shoulder belt height adjusters (if so equipped), child safety seat tether attachments and attaching hardware should be inspected after any collision. All belt assemblies should be installed new unless a qualified technician finds the assemblies show no damage and operate properly. Belt assemblies not in use during a collision should also be inspected and installed new if either damage or improper operation is noted.
NOTE: Sealant must  be applied to the tether anchor bolts when installed.
  1. Remove the rear seat cushion and rear seat bolsters. For additional information, refer to SEATING .
  2. Remove the package tray trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  3. Remove the tether anchor bolt and the safety seat tether anchor.
    • To install, tighten to 20 Nm (15 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals