Removal and Installation

CAUTION: Prior to the removal of the module, it is necessary to upload module configuration information to the appropriate diagnostic equipment. This information needs to be downloaded into the new module once installed. For additional information, refer to MODULE CONFIGURATION .

CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.

Disconnect the battery. For additional information, refer to BATTERY MOUNTING AND CABLES .
Remove the LH scuff plate.

Fig 1: Locating LH Scuff Plate
Courtesy of FORD MOTOR CO.
Remove the LH A-pillar lower trim panel.

Fig 2: Removing LH A-Pillar Lower Trim Panel
Courtesy of FORD MOTOR CO.
Position the carpet aside.
Remove the 2 nuts and position the auxiliary junction box aside.

Fig 3: Removing Position Auxiliary Junction Box Nuts
Courtesy of FORD MOTOR CO.
Disconnect the 5 FEM electrical connectors.
Remove the 3 FEM bolts and the FEM.
- To install, tighten to 9 Nm (80 lb-in).

NOTE: Once the FEM is installed, it is necessary to download the module configuration information from the diagnostic tool into the new module. For additional information, refer to MODULE CONFIGURATION .

To install, reverse the removal procedure.