Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lincoln >> 2004 >> Town Car Protection Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Automatic Transaxle/Transmission) >> In-Vehicle Repair >> Transaxle Support Insulator - Front >> Installation

Transaxle Support Insulator - Front: Installation

WARNING: This page is about a different car, the 2002 Mercury Villager. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The transaxle may need to be slightly lowered to install the support insulator.
  1. Install the support insulator.
    1. Install the support insulator.
    2. Install the through bolt.
      Fig 1: Installing Through Bolt
      G03412290Courtesy of FORD MOTOR CO.
  2. Install the front transaxle support insulator bolts.
    Fig 2: Installing Front Transaxle Support Insulator Bolts
    G03412291Courtesy of FORD MOTOR CO.
  3. Remove the jack.
  4. Install the engine splash shield.
scientia non olet · About Mike's Workshop Manuals