Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lincoln >> 2004 >> Aviator AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1400 (MULTIFUNCTION Electronic Modules System) >> Removal And Installation >> Module - Driver Door (DDM) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Prior to removal of the module, it is necessary to upload the module configuration information to a diagnostic tool. This information needs to be downloaded into the new module once installed. For additional information, Refer to MODULE CONFIGURATION .
  1. Disconnect the battery. For additional information, Refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the driver door trim panel. For additional information, Refer to INTERIOR TRIM AND ORNAMENTATION .
  3. Disconnect the electrical connectors from the DDM.
    Fig 1: Disconnecting Electrical Connectors From DDM
    G04003789Courtesy of FORD MOTOR CO.
  4. Remove the DDM.
    Fig 2: Removing DDM
    G04003790Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals