Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lincoln >> 2003 >> Town Car Protection Series >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Acceleration Control System >> Removal And Installation >> Accelerator Pedal and Shaft - Cable, Memory Pedals >> Installation

Accelerator Pedal and Shaft - Cable, Memory Pedals: Installation

  1. Install new drive cable/sensor assembly to the motor.
  2. Remove the tie strap.
    Fig 1: Locating Tie Strap
    G01338013Courtesy of FORD MOTOR CO.
  3. Align tabs on protective shell with slots on the drive motor end-cap.
    Fig 2: Aligning Tabs With Slots
    G01338014Courtesy of FORD MOTOR CO.
  4. Snap tabs on protective shell into slots on motor end-cap until fully seated.
    Fig 3: Snapping Tabs Into Slots
    G01338015Courtesy of FORD MOTOR CO.
  5. Install the accelerator pedal and shaft assembly. For additional information, see ACCELERATOR PEDAL AND SHAFT - ADJUSTABLE .
  6. Connect the battery ground cable. For additional information, see BATTERY, MOUNTING & CABLES .
scientia non olet · About Mike's Workshop Manuals