Gear Mode (Drive Mode)

Gear mode is used to test transmission shift functions. The OSC COMMAND VALUES allow for the following options:

1. (1)  - PCM selects 1st gear.
2. (2)  - PCM selects 2nd gear.
3. (3)  - PCM selects 3rd gear.
4. (4)  - PCM selects 4th gear.
5. (5)  - PCM selects 5th gear.

Perform the following procedure for GEAR MODE:

• Select OUTPUT STATE CONTROL.
• Select TRANS-DRIVE MODE.
• Select PIDs to be monitored.
• Monitor all selected PIDs during test.
• Select "Parameters - GEAR".
• Select OSC COMMAND VALUE 1-5, then press SEND.
• Re-select OSC value 1-5, then press SEND.
• Select "XXX", then press SEND at any time to cancel any command sent.