Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lincoln >> 2002 >> Continental >> Repair and Diagnosis >> External Pages >> Different car >> Section 231 (MULTIFUNCTION Electronic Module System) >> Removal And Installation >> Module - Driver Door (DDM) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2002 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Prior to removal of module, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new module once installed. For additional information, refer to MODULE CONFIGURATION .
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the driver door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  3. Disconnect the electrical connectors from the driver door module (DDM).
    Fig 1: Disconnecting Electrical Connectors From Driver Door Module (DDM)
    G02204036Courtesy of FORD MOTOR CO.
  4. Remove the DDM.
    Fig 2: Removing Driver Door Module (DDM)
    G02204037Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals