Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lincoln >> 2000 >> Navigator RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 532 (Engine System-General Information) >> General Procedures >> Connecting Rod - Large End Bore

Connecting Rod - Large End Bore

WARNING: This page is about a different car, the 2004 Lincoln Navigator and 2004 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
  1. Tighten the bolts to specification, then measure the bore in two directions. The difference is the connecting rod bore out-of-round. Verify the out-of-round is within specification.
    • Refer to the appropriate article in ENGINES for the procedure.
    • If out of specification, install new components as necessary. Refer to the appropriate article in ENGINES for the procedure.
    Fig 1: Identifying Connecting Rod - Large And Bore Diameter Measuring Points And Directions
    G02785599Courtesy of FORD MOTOR CO.
scientia non olet · About Mike's Workshop Manuals