Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lincoln >> 2000 >> Navigator 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 580 (Windows And Glass) >> Removal And Installation >> Window Control Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Lincoln Navigator and 2004 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

    Navigator front 

  1. Lift up on the center console armrest.
  2. Remove the center console window control switch panel.
    • Remove the pin-type retainer.
    Fig 1: Removing Center Console Window Control Switch Panel
    G02785398Courtesy of FORD MOTOR CO.
  3. Disconnect the electrical connectors and remove the window control switch.
    • Release the locking tabs.
    Fig 2: Disconnecting Electrical Connectors And Removing Window Control Switch
    G02785399Courtesy of FORD MOTOR CO.

    4. Expedition front and Expedition passenger rear 

    NOTE: Driver side Expedition shown, all others similar.
    Fig 3: Removing Window Control Switch Panel
    G02785400Courtesy of FORD MOTOR CO.
  4. Remove the window control switch panel.
  5. Disconnect the electrical connector(s) and remove the window control switch.
    • Release the locking tabs.

    6. Navigator passenger rear 

    Fig 4: Disconnecting Electrical Connector(s) And Removing Window Control Switch
    G02785401Courtesy of FORD MOTOR CO.
  6. Remove the rear door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  7. Remove the window control switch from the door trim panel.

    8. All vehicles 

  8. To install, reverse removal procedure.
scientia non olet · About Mike's Workshop Manuals