Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lincoln >> 1992 >> Mark VII LSC >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Crankshaft Sensor (3.0L SHO) >> Installation

Crankshaft Sensor (3.0L SHO): Installation

  1. Route sensor wiring harness through belt cover. Install sensor assembly on mounting pad, and loosely install retaining screws. DO NOT tighten screws yet.
  2. Set clearance between crankshaft sensor and vane on crankshaft pulley to .03" (.8 mm). Tighten screws to specification. See TORQUE SPECIFICATIONS  at end of article. Install lower timing belt cover. Install crankshaft pulley, and tighten bolt to specification. To complete installation, reverse removal procedure.
scientia non olet · About Mike's Workshop Manuals