Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2025 >> NX 450h+ Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - Service Information >> Camshaft Oil Control Solenoid >> Removal [11/2021 - ] >> Procedure

Removal [11/2021 - ]: Procedure

  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY 
    Refer to PROCEDURE - Step 20
  2. DISCONNECT NO. 2 EARTH WIRE 
    1. GTY1076608Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY 
    1. GTY1078282Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE CAM TIMING OIL CONTROL SOLENOID ASSEMBLY 
    1. GTY1077251Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the cam timing oil control solenoid assembly connector.
      2. Using an 8 mm socket wrench, remove the 2 bolts and cam timing oil control solenoid assembly from the No. 2 timing chain cover assembly.
        NOTE:

        If the cam timing oil control solenoid assembly has been struck or dropped, replace it.

  5. REMOVE CAM TIMING OIL CONTROL SOLENOID O-RING 
    HINT: 
    Perform this procedure only when replacement of the cam timing oil control solenoid O-ring is necessary.
    1. GTY1075683Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the cam timing oil control solenoid O-ring from the cam timing oil control solenoid assembly.
        NOTE:
        • When removing the cam timing oil control solenoid O-ring, be careful not to damage the O-ring groove of the cam timing oil control solenoid assembly.
        • If the O-ring groove of the cam timing oil control solenoid assembly is damaged, replace the cam timing oil control solenoid assembly with a new one.
scientia non olet · About Mike's Workshop Manuals