On-Vehicle Inspection [10/2018 - 07/2022]: Procedure
- INSPECT ACCELERATOR PEDAL(W/SENSOR) ROD ASSEMBLY
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Data List / Accel Position Sensor No. 1 Voltage and Accel Position Sensor No. 2 Voltage.
Powertrain > Engine > Data List
Tester Display Accelerator Position Sensor No. 1 Voltage Accelerator Position Sensor No. 2 Voltage - Read the values displayed on the Techstream.
Standard Voltage
Tester Display Condition Specified Condition Accel Position Sensor No. 1 Voltage Accelerator pedal is fully released 0.5 to 1.1 V Accelerator pedal is fully depressed 2.6 to 4.5 V Accel Position Sensor No. 2 Voltage Accelerator pedal is fully released 1.2 to 2.0 V Accelerator pedal is fully depressed 3.4 to 4.75 V If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.