Inspection [09/2014 - ]: Procedure

INSPECT FUEL INJECTOR ASSEMBLY

NOTE:

This inspection aims at checking the fuel injector assembly for an open or short. Because the fuel injector assemblies of this vehicle are a high-pressure type, fuel injection volume cannot be checked.

Measure the resistance according to the value(s) in the table below.

Standard Resistance

Tester Connection	Condition	Specified Condition
1 - 2	20°C (68°F)	1.74 to 2.04 Ω

If the result is not as specified, replace the fuel injector assembly.

*a	Component without harness connected (Fuel Injector Assembly)