Inspection [09/2014 - ]: Procedure
- INSPECT SEAT MEMORY SWITCH
- Measure the resistance according to the value(s) in the table below.
*a M1 Switch *b M2 Switch *c M3 Switch *d SET Switch *e Component without harness connected
(Seat Memory Switch)Standard Resistance
Tester Connection Condition Specified Condition 1 - 5 M1 switch pressed Below 100 Ω M1 switch not pressed 1 MΩ or higher 2 - 5 M2 switch pressed Below 100 Ω M2 switch not pressed 1 MΩ or higher 3 - 5 M3 switch pressed Below 100 Ω M3 switch not pressed 1 MΩ or higher 4 - 5 SET switch pressed Below 100 Ω SET switch not pressed 1 MΩ or higher If the result is not as specified, replace the seat memory switch.
- Measure the resistance according to the value(s) in the table below.