Inspection [09/2014 - ]: Procedure
- INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
*a Lock *b Unlock *c Component without harness connected
(Power Window Regulator Switch Assembly)Standard Resistance
Tester Connection Condition Specified Condition 12 (L) - 5 (GND) Lock switch pushed Below 200 Ω 12 (L) - 5 (GND) Lock switch not pushed 1 MΩ or higher 7 (UL) - 5 (GND) Unlock switch pushed Below 200 Ω 7 (UL) - 5 (GND) Unlock switch not pushed 1 MΩ or higher If the result is not as specified, replace the power window regulator switch assembly.
- Measure the resistance according to the value(s) in the table below.