Inspection [10/2014 - ]: Procedure
- INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (BRAKE HOLD SWITCH)
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 8 (SLT1) - 16 (GND1) Switch not pushed 1 MΩ or higher Switch pushed Below 2.5 Ω If the result is not as specified, replace the integration control and panel assembly (brake hold switch).
*a Component without harness connected
(Integration Control and Panel Assembly (Brake Hold Switch))
- Measure the resistance according to the value(s) in the table below.