How To Proceed With Troubleshooting [09/2015 - ]: Procedure

Result

Result: 

NEXT 

See step  2

Standard Voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result

Result: 

NEXT 

See step  3

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2015 - 08/2020] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2020 - ] )

Result: 

A 

See step  4

1. Check the indicator.

   Refer to DIAGNOSIS SYSTEM [09/2015 - ] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  5

1. Check for DTCs.

   Refer to DTC CHECK / CLEAR [09/2015 - ] 

2. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [09/2015 - ] 

3. Recheck for DTCs.

   Refer to DTC CHECK / CLEAR [09/2015 - ] 

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

Result: 

B 

GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [09/2015 - ]  

Result: 

A 

See step  6

1. Refer to the Problem Symptoms Table (Refer to PROBLEM SYMPTOMS TABLE [09/2015 - ] ).

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

Result: 

B 

See step  8

Result: 

A 

See step  7

1. Terminals of ECU.

   Refer to TERMINALS OF ECM [09/2015 - ] 

2. Data List / Active Test.

   Refer to DATA LIST / ACTIVE TEST [09/2015 - ] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

See step  9

Result

Result: 

NEXT 

END