Installation [10/2023 - ]: Procedure

1. Connect the No. 8 height control tube and rear No. 8 height control tube.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	No. 8 Height Control Tube
   *2	Rear No. 8 Height Control Tube

   Refer to PRECAUTION [10/2017 - ]

   NOTE:

   • Connect the height control tube uniformly in alphabetical order.
   • Replace the O ring, plate and No. 2 connector with new ones.
2. Install the height control way with the bolt.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf) 

3. Connect the connector.

1. Install the front wheel RH.

   Refer to INSTALLATION [10/2023 - ]

2. Check the connections of the tubes for air leakage.

   Refer to OPERATION CHECK [10/2017 - ]

3. Remove the front wheel RH.

   Refer to PROCEDURE - Step 1

1. Install the front fender liner RH with the 11 screws and 13 clips.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   clip

   screw

1. Attach the 3 claws to install the front fender wheel opening moulding RH.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to PROCEDURE - Step 117

Refer to INSTALLATION [10/2023 - ]

1. Change the height control switch from the "NORM" position to the "HIGH" position and back to the "NORM" position again.
2. Measure the vehicle height.

   Refer to PROCEDURE - Step 2

Refer to ADJUSTMENT [10/2023 - ]

Refer to OPERATION CHECK [10/2017 - ]