Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2021 >> LC 500h >> Repair and Diagnosis >> Suspension >> Suspension Control Systems >> Suspension Control System - Service Information >> Front Acceleration Sensor >> Removal [05/2023 - ] >> Procedure

Removal [05/2023 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

    Refer to BEFORE DISCONNECTING BATTERY [05/2023 - ]

  2. REMOVE NO. 2 DECK BOARD 

    Refer to PROCEDURE - Step 11

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 

    Refer to PROCEDURE - Step 3

  4. REMOVE FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 10

  5. REMOVE FRONT DOOR SCUFF PLATE RH 

    Refer to PROCEDURE - Step 11

  6. REMOVE FRONT DOOR OPENING TRIM COVER LH 

    Refer to PROCEDURE - Step 12

  7. REMOVE FRONT DOOR OPENING TRIM COVER RH 

    Refer to PROCEDURE - Step 13

  8. REMOVE ACCELERATION SENSOR 
    1. for LH side:
      1. Fold back the floor carpet.
      2. Disconnect the connector from the acceleration sensor.
        GTY820033Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      3. Remove the 2 nuts and acceleration sensor.
        NOTE:
        • Avoid any impact to the acceleration sensor.
        • Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
    2. for RH side:
      1. Fold back the floor carpet.
      2. Disconnect the connector from the acceleration sensor.
        GTY820032Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      3. Remove the 2 nuts and acceleration sensor.
        NOTE:
        • Avoid any impact to the acceleration sensor.
        • Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
scientia non olet · About Mike's Workshop Manuals