Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2021 >> LC 500 2D Convertible >> Repair and Diagnosis >> Suspension >> Suspension Control Systems >> Suspension Control System - Service Information (Convertible) >> Front Acceleration Sensor >> Installation [07/2020 - 05/2023] >> Procedure

Installation [07/2020 - 05/2023]: Procedure

  1. INSTALL ACCELERATION SENSOR 
    1. for LH side:
      1. Install the acceleration sensor with the 2 nuts.

        Torque: 5.5 N.m (56 kgf/cm, 49 in.lbf) 

        NOTE:
        • Avoid any impact to the acceleration sensor.
        • Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
      2. Connect the connector.
      3. Return the floor carpet to its original position.
    2. for RH side:
      1. Install the acceleration sensor with the 2 nuts.

        Torque: 5.5 N.m (56 kgf/cm, 49 in.lbf) 

        NOTE:
        • Avoid any impact to the acceleration sensor.
        • Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
      2. Connect the connector.
      3. Return the floor carpet to its original position.
  2. INSTALL FRONT DOOR OPENING TRIM COVER LH 

    Refer to PROCEDURE - Step 33 [07/2020 - 10/2022] , or refer to PROCEDURE - Step 33 [10/2022 - 05/2023]

  3. INSTALL FRONT DOOR OPENING TRIM COVER RH 

    HINT: 

    Use the same procedure described for the LH side.

  4. INSTALL FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 35 [07/2020 - 10/2022] , or refer to PROCEDURE - Step 35 [10/2022 - 05/2023]

  5. INSTALL FRONT DOOR SCUFF PLATE RH 

    HINT: 

    Use the same procedure described for the LH side.

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Refer to INSTALLATION [07/2020 - 05/2023]

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [07/2020 - 05/2023]

scientia non olet · About Mike's Workshop Manuals