Installation [05/2023 - ]: Procedure

INSTALL ACCELERATION SENSOR
1. for LH side:
  1. Install the acceleration sensor with the 2 nuts.
    Torque: 5.5 N.m (56 kgf/cm, 49 in.lbf)
    NOTE:
    Avoid any impact to the acceleration sensor.
    
    Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
  2. Connect the connector.
  3. Return the floor carpet to its original position.
2. for RH side:
  1. Install the acceleration sensor with the 2 nuts.
    Torque: 5.5 N.m (56 kgf/cm, 49 in.lbf)
    NOTE:
    Avoid any impact to the acceleration sensor.
    
    Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
  2. Connect the connector.
  3. Return the floor carpet to its original position.
INSTALL FRONT DOOR OPENING TRIM COVER LH
Refer to PROCEDURE - Step 38
INSTALL FRONT DOOR OPENING TRIM COVER RH
HINT:

Use the same procedure described for the LH side.
INSTALL FRONT DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 40
INSTALL FRONT DOOR SCUFF PLATE RH
HINT:

Use the same procedure described for the LH side.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to INSTALLATION [05/2023 - ]
INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Refer to AUTOMATIC LEARNING CHART [05/2023 - ]